(405) 806-1010

3 best techniques you need to know to clean glass

3 best techniques you need to know to clean glass
Bright Cleaning Queens

If you are cleaning entire windows, it is always better to start with the frames, because if you do it on the contrary, you may re-dirty the crystals that have taken you so hard to clean.
Start washing the windows on the outside: fences, frames, blinds, because it will surely be the part with the most dirt due to accumulation of dust and pollution.
Since you will use water and products that can slip, in cleaning windows located on painted or wallpapered walls on the inside, it is better to pre-cover with plastic roll the part of wall that you are going to work, to prevent dirt from dripping and soiling them.
It also covers the floor, the area where you are going to do the cleaning of crystals, whether it is wooden or carpeted, and if you do not have plastic on hand, use a sheet or a sufficiently large cloth.
Techniques for cleaning glass in large windows and storefronts
The best techniques for cleaning large glass from storefronts, or cleaning large window panes that are accessible, are commonly used by professional glassmakers.
To do this you will need to use a sprayer to which to incorporate a solution of soapy water clean moons.
You'll also need a sponge, a bucket of water, a few cotton rags, and a soft brush or bayette to remove the outer powder previously, plus a racket with rubber lips. If you go to clean crystals, you come across solid debris like stickers attached, or other solid debris, you'll also need a glass blade to help you detach them.
Start by passing the brush or bayette through the frames, clean or change the tool and pass it back through the outside of the glass without pressing, to remove dust. Then clean with a bayette with soapy water drained the frames on the outside, rinsing and draining in water alone, for cleaning windows.
Now spray with the spray on one of the leaves, using the sponge to rub and spread the soapy water. With the help of the racket, it begins to make passes on the glass, placing the rubber lips on the surface of the glass.
After each pass you have to remove the dirt that collects the rubber, inserting this part into a bucket of water, or with the help of a clean and moistened cloth.
To finish cleaning glass, use the cotton cloth to remove the relays and top corners.
Based on this base, there are different techniques to clean glass as far as the movement of the racket, which we will explain below:
Technique to clean glass with horizontal or vertical movement of the racket
Within these techniques to clean glass, in each case, you must use the one that is most comfortable depending on the shape of the window.
Once sprayed the soapy product, which can be composed of water and dishwasher, or water and ammonia, or water and vinegar, it is about supporting the racket vertically on the top left of the glass, forever in contact with the surface, slide it to the right, and then clean the rubber, to start again on the next line riding on about three fingers of the previous pass , so until you finish at the bottom.
To move the shear vertically cleans crystals, you will simply have to place it on the top left in a horizontal position, and start sliding down taking care that the soap and water does not slip out of the glass, clean the rubber and start again also riding on the previous band about three centimeters.
Technique for cleaning glass with fan racket movement
This type of glass cleaning technique requires more experience, and is performed when the crystals are cleaned assiduously, so they do not retain as much dirt.
In any case, if you have done window cleaning for a long time, and you want to try, you will have to perform the previous steps as explained above, and once you are going to use the crystal-cleaning racket, start from the top corner, placing the rubber upright and sliding it to the opposite end in line, but when you get to that point , without lifting the racket, you must rotate the wrist to go down the line, and continue the process in the opposite direction, and so on until finish.
Technique for cleaning glass in high or hard-to-reach windows
In order to clean difficult crystals, you will need to incorporate a telescopic handle into the moon-cleaning accessory, or racket, which in this case must have double edge, on the one hand, sponge to impregnate liquid, which in this case is better not to foam, ammonia type, and on the other the rubber to remove dirt and moisture.
Depending on the shape of the window, you'll need to apply vertical or horizontal movements to clean the glass.
And be patient because having to work with pole, in this type of techniques to clean glass you will have to press more, to get the contact of the racket against the glass, which is more tired, and the first results are not usually impeccable, so you will have to review several times.
Technique for cleaning embossed crystals
To wash windows with this type of beveled crystals, it is better not to use soap, as it would be very difficult to remove the remains that get between the drawings, so it is better to use ammonia water, or cleaning vinegar.
To do this mix in a bucket water and one of these products, and with the help of a drained sponge, apply the clean glass solution to the glass.
Then go over the entire surface again, but now only rinsing with water. It ends up drying as usual with a microfiber cloth, or a pure cotton cloth. In any case, cleaning imperfections are not so easily noticeable in this type of crystals.
Bright Cleaning Queens | This Is the BEST Way to Clean a Mirror